I asked ChatGPT for help, and it gave me a lot of useful suggestions, but nothing has worked so far. I used CHKDSK commands, and it took about an hour to check the drive, but it didn't solve anything. From Device Manager, I could see that there were no problems with the new processor or the dedicated graphics card. The only thing I CAN do is enter Safe Mode, and the PC works fine there. The keyboard lights turn off, and the red light under the mouse turns off too (it always does this, not just when trying to boot from the USB to reinstall Windows). I tried reinstalling Windows from a USB drive, but encountered the same problem: the Windows logo appears, then after about 4 seconds, the screen goes black, and the monitor shows "no signal". I disabled the integrated graphics and tried with the dedicated card, but still nothing. I removed the dedicated graphics card and tried with integrated graphics, but no luck. I've removed the motherboard battery multiple times, tried every BIOS boot configuration, disassembled and reassembled everything, checked all the cables, and everything seems fine. From Safe Mode, I was able to use CMD commands to check if the drives were okay, and they were. I thought this was a significant breakthrough because it showed me that the processor and integrated graphics were indeed working. In fact, I'm writing this from Safe Mode. One thing I discovered that helped a bit was that by pressing F8, I could enter Safe Mode, and Safe Mode with Networking. I finally decided to leave it on the latest version. Again, I thought this might be the solution, but it wasn't. Then, on the same website, I saw that the next version (F51g) adds support for Vermeer and Cezanne processors, so I thought maybe the 4600g would be compatible with it. I also have to mention that Bristol Ridge processors (i.e., the A8 9600 I had) are not supported with this BIOS version and onward. Note: NO Bristol Ridge processors support.Īs it says, Ryzen 4000 G-Series is now supported.Change default status of AMD PSP fTPM to Enabled for addressing basic Windows 11 requirements.Update AMD AGESA ComboV2 1.2.0.5 for Ryzen 4000 G-Series APU support.Introduce capsule BIOS support starting this version.Major vulnerabilities updates, customers are strongly encouraged to update to this release at the earliest.Credits to "Assaf Carlsbad and Itai Liba from SentinelOne".Here's the information about that BIOS version: I thought there might have been an issue with the BIOS update, so since I could still access it, I tried updating to the specific version (F51d) hoping it would fix the problem, but to my surprise, it didn't. It would show the motherboard logo, then the Windows logo, but after about 4 seconds, the screen would go black indefinitely. ![]() ![]() I configured the boot settings in the BIOS because they had been reset, and set it to boot from my SSD where Windows is installed. Initially, I saw the motherboard logo during boot-up, but then Windows wouldn't start. I found online recommendations to update to the latest version, so I did. Before doing anything, I researched whether I should update to the latest version or specifically to F51d. So, I checked the official motherboard website and found out that I needed to update the BIOS to version F51d (I had version F50d). I installed the new processor, but I didn't get any display. ![]() Initially, I thought I might need to update the BIOS, but I was hoping I wouldn't have to because I had previously updated it to use a borrowed Ryzen 5 3600. On Thursday at 6 PM, my new processor, a Ryzen 5 4600g, arrived. Power Supply: Aureox Powerfull ARXGP-500W Plus, it's really frustrating because I bought this new processor and can't do anything with it. I've never reached out for help before because I've always been able to figure things out with patience and reading, but this problem has gone beyond my capabilities.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |